XRAY - Model racing cars
http://forum.teamxray.com/

aluminum steering plate and aluminum rear hub hole positions
http://forum.teamxray.com/viewtopic.php?f=101&t=19601
Page 1 of 1

Author:  lijiayang1988 [ Wed Sep 27, 2017 04:00:01 ]
Post subject:  aluminum steering plate and aluminum rear hub hole positions

Hi, Martin
Just a quick question:
Can you please tell me compared to the stock composite parts, how can I match all the hole positions on the aluminum steering plate and rear hubs?

Especially for the aluminum rear hub, for example if I am running the middle hole on the stock composite rear hub, which hole should I use on the aluminum hub to match the same geometry? How thick the shims I should use?

Thanks a lot.

Author:  Martin Bayer [ Thu Sep 28, 2017 07:08:48 ]
Post subject:  Re: aluminum steering plate and aluminum rear hub hole posit

Hello

To have similar feeling position like composite steering ackerman you need you use inside back hole with 5mm shims under.
Alu rear hub i suggest front out side position. But if you want to go close to what you have on composite go to rear position on middle with 5mm shims.

Page 1 of 1 All times are UTC + 2 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/