XRAY - Model racing cars
http://forum.teamxray.com/

new Futaba servos only 4.8v ??
http://forum.teamxray.com/viewtopic.php?f=11&t=10846
Page 1 of 1

Author:  ojnab [ Sun Oct 10, 2010 12:19:11 ]
Post subject:  new Futaba servos only 4.8v ??

Hi there.
I need to replace the OEM servo.
Ive been looking at Futaba S3115 (replacement for 3101) & S3107. Both are at really good prices.
Its only 4.8v, & not recommended for 6v.
Were the original 3101 6v ??
Any recommendations for Fubaba 6v servos's that arn't too expensive??

Author:  Roelof [ Sun Oct 10, 2010 13:34:46 ]
Post subject:  Re: new Futaba servos only 4.8v ??

Most BEC systems in ESC's do give 5~5.5 volt and should be no problem.

Does it need to be a Futaba? I am runng a Hitec HS5084mg and I love it.

Author:  ojnab [ Mon Oct 11, 2010 08:32:36 ]
Post subject:  Re: new Futaba servos only 4.8v ??

Thanks for the answer.
I orderd a Futaba S3107. Need to keep costs down a bit (I usually regret cheap servo's, so fingers crossed)
In the past Ive had major issues with other brand servos in my 1/10's, so decided to go
with Fut.
-Have had to chuck out 2 new (el cheapo) Futaba S3003 though, so I guess even the Good brands gave some dud's

Author:  Roelof [ Mon Oct 11, 2010 13:51:56 ]
Post subject:  Re: new Futaba servos only 4.8v ??

Take a look at Savöx, they are very afordable end have a good quality. I know there is a Micro sized servo.

http://www.savoxservos.nl/?p=1646
http://www.savoxservos.nl/?p=1652 (metal gear)

But you have ordered a Futaba, it will work with the power from the ESC.

Author:  Mini_Me [ Mon Oct 11, 2010 17:53:26 ]
Post subject:  Re: new Futaba servos only 4.8v ??

The only thing that you might notice is it seems to have a lower speed for its turning radius versus the stock. (Stock ~.12 Futuba ~.15)

Page 1 of 1 All times are UTC + 2 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/