XRAY - Model racing cars
http://forum.teamxray.com/

Xb2 help
http://forum.teamxray.com/viewtopic.php?f=111&t=27433
Page 1 of 1

Author:  Dakota3006 [ Fri Mar 08, 2019 20:09:31 ]
Post subject:  Xb2 help

I just got the -4 motor plate and is there anything special I have to do to use it ... I have the gear box raised up ... the motor hits on the gearbox and I can’t mesh the pinion to the spur ... do I need to take out the the gearbox shim or is there something I’m missing... thanks for any suggestions...

Author:  Lowe [ Mon Apr 22, 2019 21:16:46 ]
Post subject:  Re: Xb2 help

Dakota3006 wrote:
I just got the -4 motor plate and is there anything special I have to do to use it ... I have the gear box raised up ... the motor hits on the gearbox gimp freejobalert and I can’t mesh the pinion to the spur ... do I need to take out the the gearbox shim or is there something I’m missing... thanks for any suggestions...

I also need a little help with this. Help is appreciated.

Thanks in advance,
Regards,
Shane

Author:  AlexanderL [ Tue Apr 23, 2019 00:16:59 ]
Post subject:  Re: Xb2 help

Hi

You will need to run a larger spur gear. With the +4 and a 6,5t motor we have gone from 21/81 to 23/87. This will allow you to mesh properly.

/Greger

Author:  Gurney20 [ Mon May 27, 2019 09:27:51 ]
Post subject:  Re: Xb2 help

Yes a larger spur gear should help...It allows to arrange according to your desired requirements properly DQFanSurvey

Page 1 of 1 All times are UTC + 2 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/