XRAY - Model racing cars
http://forum.teamxray.com/

are you going to continue to make parts for the 13 version
http://forum.teamxray.com/viewtopic.php?f=47&t=18691
Page 1 of 1

Author:  dan r [ Wed Jun 04, 2014 04:09:50 ]
Post subject:  are you going to continue to make parts for the 13 version

are you going to continue to make parts for the 13 version or do I need to buy up stockpiles now

Author:  brano [ Wed Jun 04, 2014 05:47:05 ]
Post subject:  Re: are you going to continue to make parts for the 13 versi

I am sure XRAY will continue to stock parts also for 13 version.

Author:  JamesHealey [ Wed Jun 18, 2014 10:56:08 ]
Post subject:  Re: are you going to continue to make parts for the 13 versi

You can still buy parts for the 2011 version on various websites, the car is still using lots and lots of parts from the earlier versions, most things are backwards compatible with the RX8, the real shame with the 2013 car was the low profile shocks and shock towers, if you can grab a set of 2011/2012 or 2014 shocks & shock towers for your car, then you can use parts from any year of the car to repair/replace anything in future, plus the larger shocks can fit springs from other manufacturers too which can give a wider range of springing options.

Author:  dan r [ Sun Jun 29, 2014 01:55:04 ]
Post subject:  Re: are you going to continue to make parts for the 13 versi

so the 11/12 shocks are the same length as the 14 shocks and are the mounting positions the same on the 11/12 shock towers or should I get the 14 ones

Author:  lizardo_dlc [ Thu Jul 02, 2015 23:37:29 ]
Post subject:  Re: are you going to continue to make parts for the 13 versi

Hello,

I was looking at Amain and RC Mushroom web stores for the 13 chassis and fuel tank V2. At amain the chassis part number doesnt even exist. Where can I buy this parts? Im from Peru South America, so I need a store with international shipping. Pls help.

May I use the 14 chassis and just make the missing holes for the middle shaft support and a hole between the two new holes for the servosaver? The perimeter is the same right? Just less holes for the middle shaft support and the holes for the servosaver in a different position. Sounds little bit desperate but If I cannot find the 13 chassis? :cry: I cant throw away my car

Regards,

LDC

Page 1 of 1 All times are UTC + 2 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/