XRAY - Model racing cars
http://forum.teamxray.com/

ECCENTRIC BUSHINGS
http://forum.teamxray.com/viewtopic.php?f=8&t=19345
Page 1 of 1

Author:  MaxNSG [ Mon Jun 06, 2016 17:06:00 ]
Post subject:  ECCENTRIC BUSHINGS

Hi

I'm trying to understand more on the bushings, can someone advice me on the eccentric bushings does? I know it changes the toe and anti-squat/dive. I have a T4'16.

what about width and roll centre does? (what's is the default figures on the factory setting? - e.g: Track Width)

thanks in advance... :D

Attachments:
Screen Shot 2016-06-06 at 11.04.33 PM.png
Screen Shot 2016-06-06 at 11.04.33 PM.png [ 20.28 KiB | Viewed 1871 times ]

Author:  robbie dodge [ Mon Jun 06, 2016 23:04:49 ]
Post subject:  Re: ECCENTRIC BUSHINGS

You can adjust track width by .5-1mm each side, either going wider or narrower.

Same with roll center, you can raise or lower the roll center by .5 to 1mm, up or down by using the .5 or 1 inserts.

Similar to how you adjust toe by changing the insert on 1 end of the hinge pin. Except you would change both inserts on each end of the hinge-pin to adjust track width or roll center. Just be careful to make sure they are pointing the same direction if all you want to change is track width or roll center.

Page 1 of 1 All times are UTC + 2 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/