XRAY - Model racing cars

It is currently Wed May 22, 2019 07:55:10

All times are UTC + 2 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Servo saver is getting to move hardly under dusty conditions
PostPosted: Sat Feb 16, 2019 05:31:25 
Offline

Joined: Thu Feb 07, 2019 10:11:49
Posts: 42
My servo saver in XB9e is getting to move hardly when a dust gets inside. On a dusty track there is an issue. I loosen the spring to lower the pressure, but this affects handling of a car while the saver is clean at the beginning. Dust comes between the parts of saver and makes scratches on them.

I bought a spare servo saver, which was intended for xb9 model (#352512), but is not the same. Servo arm of saver is lower then stocked piece. I would have to put a lot of shims to keep the servo rod horizontal, which I don't like.

Does XB9 use two different versions of servo savers?


Any advice to avoid blocking the movement of servo saver is welcome.

Thanks


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group